|
|
|
|
Triangular Wave’s UV-250 sterilizer is ideally sized to provide safe disease and pathogen-free water at point-of-entry to any average-size household. The effective kill rate of micro-organ-isms, including bacteria and viruses is 99.9%.
No chemicals are added and the PH balance of the water is unchanged. Our sterilizers operate continuously, automatically and are inexpensive to run.
Source water does not require heating or cooling prior to sterilization.
These units are easy to install and only require lamp replacement every 10 to 12 months. This is a simple 10 minute procedure.
UV Monitor
This electronic safety device monitors lamp output and triggers the audible alarm when lamp output falls below recommended levels. Available in both 120V / 60Hz and 240V / 50 Hz.
|
SPECIFICATIONS
UV-250
Rated Flow: 16 Liters per minute
4 Gallons per minute
U.V. Dose @ Rated Flow: 31,500 mw/sec/cm2
Maximum Flow: 22 Liters per minute 5 Gallons per minute
UV Dose @ Maximum Flow: 22,500 mw/sec/cm2
Electrical Supply: 120V / 60Hz / 72 watt 240V / 50Hz /144 watt
Power Consumption: .6 Amp
Maximum Operating Temperature: 370C (98.60F)
Maximum Operating Pressure: 100 psi - 7 Bar
Plumbing: 3/4" N.RT. In-Out
Size: 38" x 6" x 3" (97cm x 15cm x 7.5cm)
Weight: 8 lbs (3.5 kg)
Body: 316 Stainless Steel
|
|
We recommend that the Ultraviolet
Disinfection System be installed downstream of a Triangular
Wave Deposit Control System. The Deposit Control will keep the UV
Disinfection System electrodes free of scale and other deposits for more
effective results. And, at the same time, the Deposit Control System will
help eliminate scale and biofilm deposits through the entire water system.
Without the Triangular Wave
Deposit Control System in place, the quartz sleeve may develop either a
layer of scale or slime. In either case, it is necessary to periodically
clean the quartz sleeve with an acid solution. The Deposit Control System
eliminates the need for periodic cleaning.
|
|
